Common faults of earphone socket:
1. The operation of earphone plug interface is not standard and the structure is loose, resulting in noise during sound transmission.
2. The earphone plug is exposed in the air for a long time, so that the coating on the surface is oxidized after contacting with the air, resulting in poor contact of the earphone and affecting the use effect.
3. Generally, when using headphones, in the process of plugging in and out, the internal welding between headphone plug and headphone socket will become loose after a long time, which constitutes the loosening between headphone plug and headphone socket.
4. The problem of internal disconnection of earphone cable. At the earphone plug, when the earphone shows poor contact. Move the plug, there is noise at the plug, indicating that there is a wire break at this position.
Earphone socket disturbance problem
The earphone socket power supply is a power supply that rectifies the power frequency communication into DC, then converts it into high-frequency communication through the switching circuit, and then rectifies it into stable DC. In this way, there are the following noises: first, the high-order harmonic noise caused by the distortion of the rectifier waveform of the earphone socket power supply. But when switching devices are turned on and off at high current and high voltage, their current and voltage change sharply, forming a broadband electromagnetic disturbing noise. The third is the surge current peak and high-frequency vibration noise during the registration and shutdown of rectifier diode. In addition, the earphone socket also has electromagnetic disturbance noise caused by vibration at the input end of the output filter due to the existence of transformer leakage inductance, distributed capacitance and filter inductance capacitance.
Factors affecting sound quality of earphone socket
Influencing factor I
The falling film of the earphone socket will also affect the sound quality. For the failure of the falling film of the earphone socket, you can clamp a small piece of double-sided adhesive tape with tweezers and gently lift up the local adhesion of the falling film. Pay attention to the size of the control force. After the membrane is restored, replace it as it is.
Influencing factor II
The earphone socket film is cracked, and the sound quality will be seriously affected by it. The correction method is unlikely. Even if it is repaired, the sound quality will be damaged. However, there are still ways to deal with it. If the damage of sound quality is very light, it can be ignored. First, dip a little vulcanized silica gel with a needle and apply it to the crack of the film. Be careful not to be too thick to cover the cracks. Then install the housing. Don't go to the audition right now. You should try again after two days, because the vulcanized silica gel dries slowly.